Filter
Top Products
user manual
TCS Compact series
TCS-C50T manual
page 10
4. Connect the wiring to the removable connector. A 4-way connector is supplied with
the loudspeaker. Strip the insulation back by 5mm (3/16”), insert the bare ends of
the wire into the connector (do not tin the wire) and screw down the hold-down
screw with a small flat blade screwdriver.
There are two possible connection strategies, depending on the desired circuit result
when a single unit is disconnected for trouble shooting or servicing:
Parallel Input Terminals. This allows the circuit to remain intact whenever a
speaker is disconnected. Connect the outgoing pair of wires to the same
terminals as the incoming pair of wires.
-
Power Amplifier
+ -
Speaker 1 Speaker 2 Speaker 3
-
Inp
+
Link
+
- -
Input
+
Link
+ --
Input
+
Link
+ --
Input
+
Link
+
Loop-through Terminals. All loudspeakers after this unit will be disconnected,
helping to isolate problems to a section of the distributed line while leaving the
wires connected to the connector.
Power Amplifier
- -
Inp
+
Link
+
+ -
Speaker 1 Speaker 2 Speaker 3
- -
Input
+
Link
+ --
Input
+
Link
+ --
Input
+
Link
+