Filter
Top Products
0
Troubleshooting
Check the following
guide for
the possible cause of a problem
before
contacting service.
Symptom
No power.
The power
is on, but
the DVD receiver
does not work.
Cause
•
The power cord is disconnected.
• No disc is inserted.
• Plug the power cord into the wall outlet
securely.
• Insert a disc
. (
Check that the DVD or
,
audio CD indicator in the display
window is lit.)
No picture.
No sound.
The playback
picture is poor.
The DVD
receiver
does not start
playback.
The remote
control
does not work
properly.
• The TV is
not set to receive DVD signal
output.
• The video cable is not connected
securely.
•
The connected TV power is turned off.
• The equipment connected with the
audio cable is not set to receive DVD
signal output
• The audio cables are not connected
securely.
• The power of the equipment connected
with the audio cable is turned off.
• The Digital Audio Output is set to the
wrong position.
• The disc is dirty.
• No disc is inserted.
•
An unplayable disc is inserted.
• The disc is placed upside down.
• The disc
is not placed within the guide.
• The disc is dirty.
• The Rating level is set.
• The remote
control is
not pointed at the
remote sensor of the DVD
receiver.
• The remote control is too
far from the
DVD receiver.
• There is an obstacle in the path of the
remote control and the DVD receiver.
• The batteries in the remote control are
exhausted.
• Select the appropriate video
input mode
on the TV
so the picture
from the DVD
receiver appears
on the TV screen.
• Connect the video
cable into the jacks
securely.
• Turn on the TV.
• Select the correct input mode of the
audio receiver so you can listen to the
sound from the DVD receiver.
• Connect the audio cable into the jacks
securely.
• Turn on
the equipment connected with
the audio cable.
• Set the Digital
Audio Output
to the correct
position, then turn on the
DVD receiver
agars by pressui9 On/standby(l/U).
• Clean the disc.
• Insert a disc
. (
Check that the DVD, or audio
CD indicator in the DVD display is lit.)_
• Insert a playable disc. (Check the disc
type, color system and Regional code.)
• Place the disc with the playback side
down.
• Place the disc on the disc tray correctly
inside the guide.
• Clean the disc.
• Cancel the Rating function or change
the rating level.
• Point the remote control at the remote
sensor of the DVD receiver.
• Operate
the remote control within about
23 ft (7 m).
• Remove the obstacle.
•
Replace the batteries with new ones.
41