Filter
Top Products
Connecting the FM and AM(MW) Antennas
If AM reception is
poor, connect an
outdoor AM
anterna(not
supplied).
COAXIAL
IM
If FM reception is poor,
connect an outdoor
FM antenna
(not supplied).
FM Antenna (supplied)
Snap the tabs on the loop into the
slots of the base to assemble the
AM loop antenna.
Cooling fan (See 'About Cooling Fan" below.)
Q
FM antenna
connection
1. Connect
the FM antenna
supplied to the FM 75t2
COAXIAL terminal as temporary measure.
2. Slowly move
the antenna wire around
until you
find a location where reception is good, then
fasten it to a wall or other rigid surface.
• If reception is poor, connect an outdoor antenna.
Before attaching a 75Q coaxial cable (with a standard
type connector), disconnect the supplied FM antenna.
(About the cooling fan)
A cooling Ian c, rnaunteo on the rear panel of
the ceder unit to
prevent atinonnal i0Mperainre •n5 je NE center unit,
thus assuong
normal operation
The cooling fan automatically
slants retailing to
supply extamal cool au to t e inside of the center unit when the
internal temperature exceeds the specified limit.
0 AM(Mw)
antenna connection
1. Connect the AM loop antenna supplied
to the AM and di terminals.
2. If reception is poor
,
connect an outdoor
single vinyl
-
covered wire to the AM
terminal
. (
Keep the AM loop antenna
connected).
For safety, observe the following carefully.
• Make sure there
is good ventilason around the
center unit. Poor
ventilation could overheat and
cause damage
• DO NOT block the cooing tan
and the venblaEion openings or
holes
. (11 they are blocked
by a newspaper or loth
,
et, the heat
may not be able to escape.)
10