Filter
Top Products
29
Mains Input Voltage
100V, 110V, 120V, 220V, 230V or 240V AC at 50Hz or 60Hz
(Set within the CD1 at time of manufacture)
Dimensions
Width...............................................................................................430mm (16.9”)
Height ................................................................................................106mm (4.2”)
Depth...............................................................................................323mm (12.7”)
Fuse Ratings
Mains input fuse
100 – 125V:.........................................................................2SB slow blow 0.5A
200 – 250V:.........................................................................2SB slow blow 0.5A
(user serviceable)
Weight
Net:....................................................................................................
7.8kg (17.2lb)
(CD player only)
Gross:...............................................................................................
10.8kg (23.8lb)
(CD player, accessories and packing material)
Specifications
Explained
Rated Output........................................................................................... 2.0V
RMS
This is the reference output level to which other specifications, such as signal to
noise ratio and total harmonic distortion, are referred.
Digital Output............................................................................................0.5V
p-p
Indicates the peak-to-peak voltage of the signal from the digital output.
Output Impedance ..................................................................................... 100Ω
Output Impedance indicates the ability of the unit to drive the Line Level
Output. The low impedance of the CD1 means that it will drive any
combination of cable configuration (length, capacitance, etc.) and component
impedance with ease whilst maintaining signal integrity.
Digital Load Impedance ................................................................................75Ω
Specifies the load impedance required for the coaxial digital interconnect.
Frequency Response ................................................... 20Hz to 20kHz, ±0.5dB
Describes the frequency range where the amplitude or st
rength of the output
signal deviates from the source material by no more than 0.5dB
Total Harmonic Distortion
(THD+N)
.......................................... 0.004% @ 1kHz
Total Harmonic Distortion + Noise is the percentage of output signal which is
made up of frequencies added due to harmonics
of the fundamental frequency
and noise.