Filter
Top Products
11
The pin assignments of the balanced XLR output connectors are as follows:
Pin 1: Signal ground
Pin 2: Signal + (non-inverting)
Pin 3: Signal – (inverting)
Shield ground: Chassis ground
Caution!
Please refer to the operating manual of your preamplifier; integrated
amplifier or receiv
er to verify that the pin assignments of the input
connectors correspond to the CD1 balanced outputs. In the event that
they are not compatible, the interconnecting cable will need to be
altered to suit.
Serial Number
The serial number is unique to y
our CD1. Please record this number and store it
in a safe place. For any service related enquiry, please be prepared to quote the
product serial number to Perreaux personnel or their service representative.
Input Voltage and Fuse Rating
Input Voltage
It is important that the CD1 be operated from the correct AC mains voltage.
This unit is factory set for the voltage applicable to the original country of
destination.
The CD1 will operate satisfactorily within a voltage variation of up to ±5% of
that voltage at which the unit has been set.
If you require the voltage setting to be altered, e.g. relocation to another area,
city or country, or extraordinarily high or low voltages, please contact your
Perreaux dealer. Qualified service personnel can only perform this modification.
Caution!
Never attempt to connect the unit to the incorrect voltage. Severe
damage can result from applying incorrect voltage to the unit.
Fuse Rating
The fuse rating displayed here, refers to the rating of the mains inlet fuse.
For more information on fuse ratings, please refer to Chapter 13
“Specifications”.
Caution!
Never replace the fuses with any other ratings other than the one
specified.