Tekkeon ET2000 Headphones User Manual


 
7
USER GUIDE
To Remove the ezEarhook
1. Gently pull the ezEarhook away from the headset stem until it separates from the headset.
Powering ezTalker mini
To Turn On the Headset
1. Press and hold the TALK button until the blue LED flashes or until you hear the On tone
(approximately four seconds).
The headset turns on and is placed in standby mode, ready to
make and receive calls. While the headset is on and in standby mode, the blue LED will flash at
two-second intervals.
To Turn Off the Headset
1. When the headset is on, press and hold the TALK button until the blue then amber LEDs flash or
until you hear the Off tone (approximately four seconds).
Making Calls
You can make calls from your mobile phone, or directly from ezTalker mini using the last number
redial feature or voice dialing commands (if these features are supported by your mobile phone.)
To Make Calls From Your Mobile Phone
1. Dial the number from your mobile phone.
The call is automatically connected to your headset.
To Make Calls Using Last Number Redial (if supported by your mobile phone)
1. While the phone is in standby mode, press and hold the Volume
-
button until you hear a short
beep followed by a tone (approximately 3 seconds).
UG_et2000_v1.2_r1 10/21/05 11:05 AM Page 7