Filter
Top Products
5
USER GUIDE
To Pair the Devices
1. Turn on the mobile phone and place it next to the headset.
2. Initiate the Bluetooth device-pairing (discovery) feature on the mobile phone. Refer to the mobile
phone user guide for instructions on initiating this feature.
3. With the headset turned off, press and hold the TALK button until the blue and amber LEDs flash
alternately or until you hear Pairing tone (approximately five seconds).
4. Release the TALK button.
The headset is now in Pairing Mode.
5. Follow the mobile phone prompts, and when prompted for the passkey (also called passcode or BT
PIN), enter 0000 (the ezTalker mini passkey).
When pairing is complete, the headset will be placed in
Standby Mode, ready to make and receive calls, the amber LED will turn off, and the blue LED will
flash at two-second intervals.
To Cancel Pairing Mode
While you are in pairing mode, you can cancel the pairing process and turn off the headset.
1. While in pairing mode, press and hold the TALK button until both LEDs turn off or you hear the
Off tone (approximately three seconds).
To Connect to a Paired Device
1. Follow the menu on the paired device to connect to ezTalker mini. You must be disconnected from all
other paired devices if the headset is currently connected with any other device.
To Disconnect From a Paired Device
1. While connected to a paired device, follow the menu on the device to disconnect from ezTalker mini.
UG_et2000_v1.2_r1 10/21/05 11:05 AM Page 5