Filter
Top Products
9
USER GUIDE
To Answer a Call Waiting Call (if supported by your mobile phone)
1. When you hear two beeps while connected on a call, press and hold the Volume
-
button until
you hear a short beep followed by a long tone (approximately 3 seconds).
The original call will be
placed on hold and the new call be will be connected. Your phone will display the incoming and
connected calls.
2. While connected on a call, press and hold the Volume
-
button to toggle between the two
connected calls.
3. When connected to a call, press TALK to end the call.
You will be reconnected to the other call.
NOTE: For some mobile phones, you must configure the phone to answer calls directly on your
Bluetooth headset. Refer to the mobile phone user guide for instructions for initiating this feature.
Ending Calls
1. When you have finished your call, press the headset TALK button.
The call will be disconnected.
Transferring Calls
You can transfer calls from your mobile phone to your headset, and from your headset to your
mobile phone.
To Transfer Calls From Your Mobile Phone to The Headset
1. With the call connected to your mobile phone, press the TALK button on your headset.
The call
will be connected to your headset.
To Transfer Calls From the Headset to Your Mobile Phone
1. With the call connected to your headset, press and hold the Volume + button until you hear a
beep (approximately 3 seconds).
The call will be connected to your mobile phone.
UG_et2000_v1.2_r1 10/21/05 11:05 AM Page 9