Tekkeon ET2000 Headphones User Manual


 
8
To Make Calls Using Voice Dialing (if supported by your mobile phone)
1. Press the TALK button on your headset.
You will hear two beeps.
2. When prompted by the mobile phone (usually about five seconds), speak the name of the person
you wish to call.
The call is automatically connected to your headset.
TIP: In a noisy environment, you should dial the number from the mobile phone keypad as the loud
background noise may interfere with voice commands.
Receiving Calls
When you receive a call on your mobile phone, you will hear the mobile phone ring before you hear
the ring tone through your headset as there is a small delay before the headset recognizes the
incoming call. If you do not wish to answer the call, you can use the Call Reject feature to reject the
call and send the caller to voice mail (if available).
If the Call Waiting feature is supported by your phone, you can answer an incoming call while you
are connected on another call. In this case, the connected call is placed on hold and the incoming
call is connected. While both calls are connected, you can toggle between the calls.
To Receive a Call
1. When you hear ring tone on your headset, press the headset TALK button.
The call is
automatically connected to your headset.
To Reject an Incoming Call (if supported by your mobile phone)
1. When you hear ring tone on your headset, press and hold the TALK button until you hear two soft
beeps to reject the call (approximately four seconds).
UG_et2000_v1.2_r1 10/21/05 11:05 AM Page 8