Tascam GA-30CD Stereo Amplifier User Manual


 
2 – Part names and functions
TASCAM GA-30CD 9
o
d
f
g h
i
e
r t y
p
a
s
u
Top Panel
In addition to standard CD player functions, the CD
Trainer also has a tuner, a metronome, an oscillator and
other features.
e CD player cover
Lightly press the ø mark at the front of the cover to
open the player.
r LOOP I/O key
Use for loop playback.
Press this key to set the loop IN point (starting
point) for the currently playing or paused CD. Press
this key again to set the OUT point (ending point)
and start loop playback automatically.
When IN and OUT points are set, press and hold
this key to turn loop playback between the IN and
OUT points ON and OFF.
When IN and OUT points are not set, press and hold
this key to turn single track or all track repeat ON
and OFF. (See “Repeat playback of a selected loop”
and “All track or single track repeat playback” on
page 16.)
t TUNER/SETUP key
Press this key to turn the tuner ON and OFF. Make
detailed tuner settings using the Setup menu. (See
“Using the tuner” on page 18.)
Press and hold this key to open the Setup menu
to adjust the time display mode as well as other
functions, including tuner settings. Once in the
Setup menu, press this key to cycle through setting
items. (See the “Changing settings” chapter on
page 19.)
y Setting adjustment keys
Use the three setting change keys to adjust settings.
DOWN: Reduce values, flatten the pitch or shift the
stereo position to the left.
CENTER: Restore the default value, cancel pitch
changes or reset the stereo position to the center.
UP: Increase values, sharpen the pitch or shift the
stereo position to the right.
u CD Trainer LCD
Shows information about CD playback, etc.
i GUITAR CANCEL key
Press this key to turn Guitar Cancel ON and OFF.
The indicator lights when ON and blinks when in
setup mode. Press and hold this key to open the
Guitar Cancel setting menu. In this menu, press this
key to cycle through setting items. (See “Canceling
guitar sounds” on page 17.)
o OSC key
Press this key to start the oscillator and output an
adjustable pitch signal from the side speakers. (See
“Using the oscillator” on page 18.)
Press and hold this key to access the Calibration
menu and set the standard tuning frequency. (See
“Calibrating the tuning frequency” on page 18.)
CD Trainer section