Filter
Top Products
2 - Parts of the tape deck
TASCAM DA-45HR 17
[37]REMOTE IN
This 3.5 mm jack is used to connect the optional RC-
D45 remote control unit.
Do not use this jack to connect any remote control
unit other than one designed especially for use with
the tape deck.
[38]~ IN
Use this to connect the tape deck to the AC power
supply using the supplied cable.
Make sure that the power supply voltage matches the
voltage requirements of the tape deck as marked on
the rear panel. If there is any doubt, consult your
TASCAM dealer.
[39]BALANCED ANALOG inputs
These female XLR connectors provide balanced
inputs at a nominal +4 dBu level. The wiring of these
connectors is:1 = ground, 2 = hot, 3 = cold. The nom-
inal impedance of these connectors is greater than
25 kΩ.
[40]UNBALANCED ANALOG inputs
These RCA connectors provide unbalanced inputs at
a nominal –10 dBV level. The nominal impedance of
these connectors is greater than 50 kΩ.
[41]UNBALANCED ANALOG outputs
These RCA connectors provide unbalanced outputs
at a nominal –10 dBV level. The nominal impedance
of these connectors is less than 700 Ω.
[42]BALANCED ANALOG outputs
These XLR connectors provide balanced outputs at a
nominal +4 dBu level. The nominal impedance of
these connectors is less than 27 Ω.
The trimmer beside each connector can be used to set
the output level precisely to match the level expected
by the equipment connected to the tape deck.
The “standard” setting (and the condition in which
the unit is shipped from the factory) is with these
trimmers set to maximum (fully clockwise).