Filter
Top Products
1 – Introduction—About this manual
TASCAM CD-RW4U 7
About this manual
NOTE
This part of the manual does not cover the use of the CD-
RW4U with a personal computer—it covers the audio func-
tions of the unit only.
In this manual, we use the following conventions:
• The names of keys and controls are given in the
following typeface:
ERASE.
• When the alphanumeric portion of the display
shows a message, this is shown in the following
typeface:
TASCAM.
• If a preset indicator in the display (i.e. one which
cannot change, but is either on or off) is shown, this
is shown as follows:
SHUFFLE
.
• When referring to a front or rear panel control or
feature, the following typeface is used to show the
number of the feature (as given in the diagram in
this manual, and the corresponding explanation):
5.
• When referring to a key on the remote control unit,
the following typeface is used to show the number
of the key (as given in the diagram in this manual,
and the corresponding explanation):
5.
“Recordable” discs
In this manual, we use the term “recordable” disc to
describe a CD-R or CD-RW disc that has not been
finalized, i.e. further recording is possible on the
disc.
Special notes
Unpacking and handling the CD-RW4U
When unpacking the unit, you should find the follow-
ing items, in addition to this manual:
• The CD-RW4U unit itself
• The RC-RW700 remote control unit
• Four feet for vertical mounting
• USB cable
• 1/4” to 3.5mm stereo headphone adapter
• A 3.5” diskette containing driver software
• A CD-ROM containing CD-writing software
• Two AA batteries for the remote control unit
• This manual
• The CD-RW4U USB Operation Guide
• A Quick Start guide
Siting, etc.
The CD-RW4U can be operated in either a horizontal
or a vertical orientation.
If you want to use the unit in a vertical potion, you
must first fit the supplied feet.
Peel off the backing paper of the self-adhesive feet,
and locate them in the small (1mm) shallow depres-
sions in the right side of the unit:
When using the unit in a vertical orientation, always
make sure that it is positioned on a stable surface
where it will not topple or fall. It should always be
oriented on the feet on its right side.
Take care when inserting discs into the drive in this
orientation, as they may jam in the tray mechanism.
Do not change the orientation of the unit with a CD
loaded in the tray, as this may cause jamming.
Also note that if the unit is operated in a vertical ori-
entation, you will not be able to use 8 cm (single)