Filter
Top Products
2 – Introduction to the CD-RW4U—Remote control unit
TASCAM CD-RW4U 15
I ANALOG IN (UNBALANCED) These
RCA jacks accept analog audio signals from suit-
ably-equipped units (–10 dBV, unbalanced).
J ANALOG OUT (UNBALANCED) These
RCA jacks output analog audio signals (at –10 dBV
levels, unbalanced) to suitably-equipped units.
K USB This B type USB connector is used to
connect the CD-RW4U to a host computer when it is
being used in the USB mode. For details, see the CD-
RW4U USB Operation Guide.
L (AC power) Use the connected power cable
to connect the CD-RW4U to the AC power supply.
Always ensure that the voltage supplied is the same
as that indicated on the rear panel of the CD-RW4U.
If you are in doubt, consult a qualified electrician.
Remote control unit
1 POWER Turns the unit between standby and
power on modes (equivalent to
1)
2 OPEN/CLOSE key Opens and closes the
disc tray (equivalent to
A).
3 Number keys (0 through 10
and +10)
Use these keys for direct entry of track
numbers when playing back, or making a pro-
grammed play list.
4 CLEAR key Use this key to clear a mistaken
entry made with the number keys.
5 REPEAT key Use this key to change
between the various repeat modes when playing back
(see “Repeat play” on page 18).
6 DISPLAY key Use this key to switch
between the different display modes available.
7 MENU key Repeated presses of this key cycle
through the different menu items used to set parame-
ters (equivalent to
E).
8 ENTER key Pressing this key is equivalent to
pressing the
MULTI DIAL control B to confirm an
entry.
9 FADER key Use this key to start fade-in
recordings or to start a fade-out when recording.
A MONITOR key Use this key to output the
signals received at the currently selected input(s)
through the outputs when not recording or in record
ready mode.
B PLAY MODE key Use this key to choose
between the different playback modes.
C FINALIZE key Use this key to finalize
recordable discs. See “Finalizing” on page 12 and
“Finalizing discs” on page 27 for details (equivalent
to
D).
D ERASE key Use this key (with CD-RW discs
only) to erase tracks, or a whole disc, or to refresh a
“bad” disc, or to unfinalize a finalized disc. See
“Erasing” on page 28 for details.
E RECORD key Use this key to enter record
ready mode (equivalent to
5).
F SYNC REC key Use this key to turn syn-
chronized recording on and off (equivalent to
4).
See “Synchronized recording” on page 24 for
details).
G REC MUTE key Use this key when record-
ing, to mute the input signal for about four seconds
and then to enter record ready mode (see “Rec mute
function” on page 23).
H SEARCH keys Use these keys to move the
playback position inside a track.
I SKIP keys Use these keys to move between
tracks when playing back (equivalent to turning
B).
They are also used to set the parameter values, etc.
J STOP key Use this key to stop playback or
recording (equivalent to 7).
K PAUSE key Use this key to pause playback
or recording.
L PLAY key Use this key to start playback, or
enter record mode from record ready mode.