Filter
Top Products
30 TASCAM CD-RW4U
6 – Troubleshooting
7 – Reference and specifications
Dimensional drawing
Symptom Possible cause and remedy
No sound on playback (the disc
is playing and the time display is
incrementing)
The connections from the CD-RW4U to the amplifier system have not been made properly, or the input
source selector is not at the correct position.
No meter indication when a
source is input
Analog and/or digital volume (“Level adjustment” on page 20) is set too low. The signal is being input
through an unselected input source (“Input selection” on page 19).
D-IN UNLOCK!
A digital input source has been selected, but the source is not connected or is not switched on.
Cannot record on a disc (press-
ing
RECORD
shows
MONITOR
)
A finalized disc has been inserted. Use an unfinalized recordable disc.
PGM Full !
An attempt has been made to create more than 25 program steps.
Disc Full!
or
Cannot
Rec!
There is no space on the disc, or no tracks are available, or a general recording error has occurred.
Disc Error
The disc is bad. If it is a CD-RW disc, you may refresh it (“Refreshing a disc” on page 29), otherwise
replace the disc.
Erase Error!
An error has occurred while trying to erase the disc.
The display suddenly shows
PMA Writing
Either the disc is full (this message will be prefaced by
Disc Full!!
(“Full disc” on page 23) or an
attempt has been made to write more than 99 tracks.
Rec Error
General recording error. This may be caused by vibration or a shock during recording, for example, or
may be the result of a bad disc. Try recording again with the same disc. If the message appears again,
try a different disc.
No OPC Area!
Appears only with CD-R discs. The OPC area is full, and no further recording is possible on this disc.
Finalize the disc.
OPC Area CLR
Seen when a CD-RW disc OPC area is full, and the CD-RW4U automatically cleans up the OPC area
for further recording.
Need Repair!
Current disc needs repair. Refresh the CD-RW disc using the procedure described in “Refreshing a
disc” on page 29.
System Err!
System error.
Tray Error!
Error in the tray mechanism.
Drive Error!
Error in the drive mechanism.
20mm (0.8") 242mm (9.5")
280mm (11.0")
26mm (1")
37 mm (1.5")
16mm (0.6")
33mm (1.3")
30mm (1.2 ")
63mm (2.5")
215mm (8.5")
83mm (3.3")4mm (0.1")
150mm (5.9")
13mm (0.5")
15mm (0.6")
129mm (5.1")