Filter
Top Products
7 – Other functions
TASCAM CD-D1x4 19
4 Press MODE to view the hardware informa-
tion (the maximum speed available and the
model hardware serial number):
5 Press
MODE once more to view the number
of discs successfully copied (
OK) and the
number of discs for which copying has been
attempted (
TOTAL) so far. Note that discs
on which track extraction has been per-
formed are not included in these totals.
The Session Mode option
The SESSION MODE option should always be
left as
CLOSE.
There is one exception to this: if you are adding data
to audio discs using a computer to make CD-EXTRA
discs. Consult the reference manual of your computer
CD-R software for details.
Cascading
When two units are cascaded, the master unit can use
up to four slave drives of the slave unit.
1 With the two power switches on each unit
turned OFF, use the supplied cascade cable
to link the two units.
2 Set the switch on the rear of one unit to
MASTER, and on the other to SLAVE. Note
that if you set both to
MASTER or both to
SLAVE, neither unit will work properly.
3 Turn on the rear power switches and then
turn on the front power switches (always
turning on the slave first).
The slave unit shows
Slave Mode on the
display.
The slave front panel controls and display are dis-
abled, except for the drive eject keys, headphone
jacks and volume controls (which can be used at the
appropriate points in the different procedures).
When the cascade master is cycling through the slave
drives, it uses eight drives instead of four (slave drive
1 on the slave unit becomes drive 5, etc.).
All other operations are carried out as usual.
NOTE
If you turn off the
SLAVE
unit when two units are con-
nected in cascade mode, the
MASTER
unit cannot be
used.
H/W INFO x16
1110800000000000
OK 1321
TOTAL 1334