Filter
Top Products
7 – Other functions
18 TASCAM CD-D1x4
Erasing discs
This applies to CD-RW media only. You cannot erase
CD-R discs that have been recorded.
1 Press the
MODE key until the display shows:
2 Press
ENTER. The display shows SURE ?.
Press
ENTER for the next stage, otherwise
press
MODE. If there is a slave drive into
which a target disc has not been loaded, the
display alternates:
with
3 Insert any discs to be erased in the slave
drives, close the trays and wait for the indica-
tors to go out. Then press
ENTER.
As the discs are erased, the display shows:
NOTE
You should take care that you do not leave any CD-RW
discs that you want to retain in the slave drive trays!
Finding out about your CD-D1x4
In the event of any questions about your CD-D1x4,
you may need to discover the drive type and firm-
ware versions of the five drives installed in the unit.
1 Press the
MODE button until the display
shows:
2 Press
ENTER, and then press MODE until the
screen shows:
3 Press
ENTER. The display shows information
(maker, model and firmware version) about
the master drive (this may be different from
that shown here):
4 Press
MODE to see similar information about
slave drives:
You can press
ESCAPE to go up a level at any
time during this enquiry.
Finding out the main unit version number
1 Press the MODE button until the display
shows:
2 Press
ENTER, and then press MODE until the
screen shows:
3 Press
ENTER. The screen shows the model
and major firmware version (the number
shown may differ from the one shown here):
DISC ERASE?
(CD-RW)
INSERT
TARGET DISC
PRESS ENTER
TO START
DISC ERASE...
Please wait...
SETUP
(MODE CHANGE)
>DRIVE INQUIRY?
MASTER
TEAC
MASTER
CD-540E
MASTER
3.0A
DRIVE 1
TEAC
SETUP
(MODE CHANGE)
>F/W VERSION?
CD-D1x4
Ver 1.00