Filter
Top Products
4 TASCAM 322
The TASCAM 322 is a double auto reverse cassette
deck primarily designed for continuous playback of
background music or tape dubbing needs. A maximum
of ten 322s can be hooked up to form a sequential play
loop or to synchronize them, with one serving as the
master/source machine and the others serving as the
slave/target machines, for simultaneous tape dubbing.
Table of Contents
General Guide to the Controls and Connectors ....5
Using a Single 322 ....................................................9
Recording on either deck, or both at the
same time ..........................................................9
Continuous recording on both decks....................10
Dubbing from deck 1 onto deck 2 .......................10
Playback...............................................................11
Using just one of the two available decks.......11
Continuous play on both decks.......................11
Using the CPS function........................................12
Erasing recordings................................................12
Multiple-322 System Operation .............................13
Sequential link play..............................................13
Simultaneous dubbing onto multiple cassettes ....14
Recording an external source onto multiple
cassettes simultaneously .................................15
Care and Maintenance............................................17
Troubleshooting......................................................18
Error Messages.....................................................18
Specifications .........................................................19
Block Diagram.........................................................20
Optional Accessories :
“ LA-322 balanced amplifier kit
“ WR-7000 synchro cable (for interconnecting two or
more 322s, as shown on pp.12 and 13)
“ TZ-261 cleaning kit (except for U.S.A.)
“ HC-1 head cleaner & RC-1 rubber cleaner (U.S.A.
only)
“ Head demagnetizer
Rack Mounting
The 322 can be installed in a standard 19" rack, using
the provided 4 pairs of screws (M5 x 12) and 4
washers, as shown.
NOTE : Voltage conversion is not possible on models
sold in the U.K., Australia or Europe.
Be sure to remove the power cord from the AC outlet
before repositioning the voltage converter switch.
1. Locate the voltage selector on the rear panel.
2. Using a flat-bladed screwdriver, set to the
appropriate 230 V or 120 V position according to
your area.
VOLTAGE CONVERSION
IN NORTH AMERICA USE ONLY ON 120 V
SUPPLY.
DANS L’AMÉRIOUE DU NORD: UTILISABLE SUR
120 V D’ALIMENTATION UNIQUEMENT.
Before Getting Started