Filter
Top Products
10 TASCAM 322
When the tape on deck 1 records up to the end of the
reverse side, the tape on deck 2 will start recording,
stopping at its end of the reverse side.
The signal connected to DECK 1 is automatically
routed to DECK 2.
The procedure is essentially the same for Recording
on Either Deck, or Both at the Same Time, except:
“ The REV MODE switch must be set to CONT.
DUAL REC cannot be used in this application; put
both decks into Record Ready mode separately by
holding
RECORD and pressing PAUSE on the
individual decks. (The
INPUT and REC BAL controls
and the
DOLBY NR switch also must be set on the
individual decks.)
If you want to use an amp/speaker system to monitor
the source tape as it plays, connect your monitor
system to the output of deck 1.
1. Insert the source tape into deck 1 and a target tape
into deck 2.
2. Locate the source tape to the beginning of the
program material you intend to dub, and the target
tape to the point you want to start recording from.
3. Set the
REV MODE switch to Ä to limit dubbing
to one side only or ä for dubbing to continue
onto the reverse side automatically.
4. Press the
DUB STDBY NORM button if you intend
to dub selected portions or materials.
Use the
Hl SPEED mode when dubbing the entire
tape without interruption.
Upon selecting either DUB STDBY mode, deck 1
goes into Play Ready mode, and deck 2 goes into
Record Ready mode.
At this moment,
PLAY, STOP, F FWD and REW can
operate on deck 1 if in NORM mode. In HI SPEED
mode, only
PLAY can operate to change the record
direction (STOP can also operate but only serves to
disengage the dubbing mode).
5. If you have connected a monitor speaker system to
the output of deck 1, and have selected the HI
SPEED mode, set the
INPUT/OUTPUT switch to
SEPARATE.
6. Press the
SYNC REVERSE button if you want
whichever tape first reaches the end of the forward
side to go into Play Pause or Record Pause mode
(depending on whether the tape is the source or
target), thus waiting for the other tape to reach its
end of the forward side, so that both tapes are
simultaneously switched to start their respective
functions on their reverse sides.
SYNC REVERSE can function only when :
l . REV MODE is set to ä ;
2. DUB STDBY is pressed before SYNC
REVERSE ; and
3. Both tapes start from their forward sides.
7. To start dubbing, press the Á button on deck 2.
8. If you are in NORM mode :
When dubbing of a selection is complete, locate the
tape to the beginning of the next selection to dub.
When you press
PAUSE, STOP, F FWD or REW on
deck 1, deck 2 invariably goes into Record Pause
mode.
You can press
PAUSE on deck 2 to put deck 1 into
Play Pause mode and deck 2 into Record Pause
mode.
Continuous Recording on Both Decks
Dubbing from Deck 1 onto Deck 2
Using A Single 322