Filter
Top Products
TASCAM 322 11
9. To stop dubbing in NORM mode and exit this
mode, press
STOP on deck 2. In HIGH SPEED
mode, you can press
STOP on either deck.
1. Connect the amp/speaker system to the OUTPUT
connectors of the deck you intend to use.
2. Insert the tape into either deck 1 or 2.
3. Make the following switch settings :
“ REV MODE switch to Ä to play only one tape
side or ä to play both sides continuously.
“ DOLBY NR switch depending on the tape in use.
If REV MODE is set to Ä and you intend to play
only the reverse tape side, press the Ó button to
have the associated LED start blinking.
4. To start play, press
PLAY whose LED is blinking.
You can either connect a single amp/speaker system to
the deck 1’s output or an additional amp/speaker
system can be connected to the deck 2’s output as well.
To have both decks play sequentially :
1. Set the
INPUT/OUTPUT switch to SEPARATE if
both decks’ outputs are in use or COMMON if only
deck l’s output is in use.
2. Set the
REV MODE switch to CONT.
3. Insert the tapes into both decks.
4. Set the
DOLBY NR switch on both decks
depending on the tapes in use.
5. To start sequential play, press
PLAY on deck 1.
When deck 1 plays up to the end of the reverse side,
deck 2 automatically starts. When deck 1 plays up to
the end of the reverse side, deck 2 automatically starts
playing. When deck 2 plays up to the end af the reverse
side, deck 1 again starts playing. This process
continues until you press
STOP on either deck.
Playback
Using Just One of the Two Available Decks
Continuous Play on Both Decks
Using A Single 322