Filter
Top Products
TASCAM 322 13
A maximum of ten (10) 322s can be interconnected to
provide the following possibilities :
“ Sequential link play of multiple cassettes.
“ Dubbing onto multipie cassettes simultaneously.
“ Recording an external source onto multiple
cassettes simultaneously.
WARNING : Make all conncctions with power off.
Each time one cassette plays up to the end of the
reverse tape side, the next cassette will start.
1. Check to see that all the 322s are turned off.
2. Refer to the diagram above, and connect the first
322’s EXT CONTROL OUT to the second 322’s
EXT CONTROL IN, the second 322’s EXT
CONTROL OUT to the third 322’s EXT
CONTROL IN, and so on. Finally, connect the last
322’s EXT CONTROL OUT to the first 322’s EXT
CONTROL IN.
3. Switch on power to all the 322s.
4. Make the following switch settings on each 322 :
“ OFF/SLV/MSTR switch to OFF ;
“ REV MODE switch to CONT.
5. Insert pre-recorded tapes into decks 1 and 2 of
every 322.
6. To start sequential link play, press
PLAY on either
deck of any 322.
7. To stop play, press
STOP on the deck which is
currently in play.
NOTE
If there is a slave unit which has no tape inserted,
sequential link play will stop when this slave is
detected.
Sequential Link Play
Multiple-322 System Operation