Filter
Top Products
Tandberg Data Tape Drive Operation
14 Tandberg LTO HH Installation and User Manual
4.2.1 Write Protecting the Cartridge
The LTO cartridge can be write-protected by operating the write protect switch.
The Tandberg LTO HH tape drive detects that the write-protect switch is set and then not allow any
writing on the tape.
Figure 4.2 LTO cartridge write protect switch
4.2.2 Loading a Data Cartridge Into a Tandberg LTO HH
The cartridge must be inserted with the label facing up and the tape dust cover towards the LEDs. The
drive has Semi-Soft Load: Slide the cartridge slowly into the Drive until it stops then let go. Then the
cartridge is detected and a motor-driven load mechanism locks the cartridge automatically in the
correct position.
In order not to damage the drive or the cartridge:
• DO NOT use extensive force
• BE SURE to insert the cartridge in correct position
• Be sure to insert the cartridge all the way in until a HARD stop
1. Ensure that the LTO cartridge is correctly oriented with the arrow on the cartridge pointing up
and towards the tape drive (see Figure 4.2 for tape orientation).
2. Push the cartridge firmly into the tape drive until the point of hard stop and remove your hand.
The tape drive starts loading.
3. In case the drive will not hold the cartridge allow the cartridge to eject and settle completely.
Wait for the Activity indicator (see
Section 4.1) to turn off. Repeat the sequence from step 1.
Figure 4.3 Cartridge insertion
Tape Window
The Write Protect switch of the LTO cartridge is shown in the
non-protected position.
When the cartridge is write protected, the switch is to the right
and the area is red.
Arrow for
cartridge
orientation