D13841.08
10.2007
20
TANDBERG 3G GATEWAY
USER GUIDE
Table of
Contents
Trademarks &
Copyright
Patents &
Disclaimers
Safety/
Environmental
To Get You
Up and Going
Using the 3G
Gateway
Viewing the
System Status
Configuring
the 3G Gateway
Maintenance
& Upgrade
Services
Dial Plan
Examples
Contact
Information
Using the 3G
Gateway
TANDBERG 3G GATEWAY
USER GUIDE
The 3G Gateway is equipped with a number
of persistent default services, i.e. services
stored in the on-board non-volatile memory.
Therefore, these services will always
be available after a system restart. The
following persistent default services can be
distinguished:
Direct Inwards Dialing (DID)• – Defines a
one-on-one relation between an inbound
and an outbound number.
Dial Extension (IVR)• – Also known as
Interactive Voice/Video Response (IVR),
defines a relation between an inbound
number and an interactive service, i.e. a
menu, via which an outbound service can
be connected to. The outbound service
can be an audio or video service or an
externally connected endpoint.
TMS Corporate Directory• (phone book) – A
connection with the installed TANDBERG
Management System (TMS) phone book
is set up. Via the phone book menu an
outbound call to another endpoint, e.g. a
3G Mobile, H.323 or SIP endpoint, can be
set up.
DID – Direct Inward Dialing
Example Hotline
Entry details:
Enabled: Check
Name: H.324m-H.323
Net Type: H.324m
Prefix: 67890000
Suffix:
Service Type: Direct Inwards Dialing
Arguments:
Net Type: H.323
AV Mode: Auto + fallback to audio
Prefix: 51234
Suffix
Use Remainder: No
Allow Forwarding: No
When dialing number 67890000 this will match without leaving a
remainder. The H.323 number that will be connected to will be: 51234
(construction: prefix). When dialing number 67894321 there will be no
match. When dialing number 678900009876 one is also connected to
the same H.323 endpoint, since there is a match on 67890000 and the
remainder, i.e. 9876, is discarded. Note that
Use Remainder is set to
No!
Example
A 3G handset user calls a Dial Extension service number.1.
The 3G Gateway activates the 2.
Welcome screen and sound.
The 3G Gateway, when set in the dial plan, shows the DTMF Information screen.3.
The 3G handset user enters the extension (H.324m, H.323 or SIP alias) followed by the 4.
# (pound-sign) to indicate end of number.
The 3G Gateway starts to call the endpoint and the 5.
Connecting picture and sound are activated.
When the call is connected audio and video are transmitted through the 3G Gateway. 6.
Dial Extension (IVR) Example
Call Setup via Default Services
About Default Services