Filter
Top Products
D13841.08
10.2007
14
Table of
Contents
Trademarks &
Copyright
Patents &
Disclaimers
Safety/
Environmental
To Get You
Up and Going
Using the 3G
Gateway
Viewing the
System Status
Configuring
the 3G Gateway
Maintenance
& Upgrade
Services
Dial Plan
Examples
Contact
Information
To Get You
up and Going
TANDBERG 3G GATEWAY
USER GUIDE
The 3G Gateway requires some basic
configurations before it can be used. It will be
necessary to find the IP-address and to create
the dial-in and dial-out services to program
the ISDN-PRI Line numbers.
Make sure the 3G Gateway is Off and
connect an RS232 cable between the
3G Gateway and a PC.
Switch on the 3G Gateway.
Start a terminal program on the PC and
configure it to:
115200, 8, 1, None
Configuring via the RS 232
To assign a static IP-address, type
Xconf ip Assigment: “Static”
and
Xconf ip address <IPAddr>
To assign an
IP Subnetmask, type
Xconf ip address subnetmask
<subnetmask>
To assign an
IP Gateway address, type
Xconf ip address gateway
<gateway IP-address>
Restart the 3G
Gateway.
Start a WEB browser
and enter the IP-
address of the 3G
Gateway. Default
password: TANDBERG
Note the case sensitivity!
To configure the 3G
Gateway for UMTS
dial-in, enter PRI or BRI
numbers and dial in
number(s). For details,
see Configuring the 3G
Gateway.
To configure the 3G Gateway for IP dial in, register the 3G Gateway to a Gatekeeper and
enter H.323 services. For details, see Configuring the 3G Gateway
As an alternative to the configuration via
RS 232 you may use the LCD panel to
configure and check the IP settings, as well as
to reboot the system. This is outlined on the
next page.
Power switch
Conguring Your 3G Gateway via the RS 232
About Gateway Configuration
Configuration via the Front Panel