Filter
Top Products
12
OPERATING THE AMPLIFIER BY REMOTE CONTROL
GENERAL INFORMATION
In the drawing of the remote control handset
shown alongside the buttons marked
"
" are those which are used to con-
trol the amplifier. None of the other buttons
have any effect on the amplifier
ON
If the system is already switched
on, the
button on the re-
mote control handset switches the
system to stand-by mode.
In stand-by mode the screen just shows the
time of day. The time display indicates that
the machine is able to respond to remote
control signals. However, the power con-
sumption of the system is reduced to less
than 1 Watt in this mode. Pressing the
button on the handset a second time
switches the system on again.
Notes:
• If the system is set to single-room mode
(see SETUP functions), the machine reverts
to the settings which were in use last time
you listened to the system.
• If the system is set to multi-room mode,
only the loudspeakers in the room where
the user is located are switched on,
A in
the main room, or
B in the secondary
room. The volume is limited to "room
level" when you initially switch on.