Filter
Top Products
Loudness Maximizer
17
Adjusted output levels will be stored and will be active the next
time you boot the Loudness Maximizer. If you recognize that your
unit does not maximize to full scale, please check the Output
Level parameter first.
The Output Level attenuation is not shown in the Output PPM
meters!
Tip: The Output Level should only be used where the output
signal should permanently be lower than 0dB.
The Output Level setting will be ignored when a MIDI volume
change command is present. MIDI has first priority. Note that the
setting in the Output Level page will still show the reduced
output level, nevertheless, a MIDI volume change command may
already have reset the output level to a different value.Therefore,
if you use MIDI set Output Level to 0dB.
You leave the INFO pages by depressing STORE.
Info
9