Filter
Top Products
12
RackPack
Step 4 (Top View)
Insert the new module into the slot from the front side of the RackPack. Fix the back of the
new module with the four Phillips screws to the rear of the frame (two of the Phillips screws
needed here came with the new module, two further screws remained from unscrewing the
rear cover panel, see step 2).
Now tighten the two M4 socket screws. Put them through the holes on the top and bottom of
the aluminum panel rst, then through the top and bottom holes of the front of the module.
Fix the panel and the front of the module by tightening the M4 screws into the threads of the
housing (see step 3).
Step 5
Finally plug the multi-pin connector of the ribbon cable that corresponds to the module’s slot
into the multi-pin socket of the new module. Make sure that the connection is safe and tight
by plugging the connector completely into the socket.
IMPORTANT: Only pull or push the connector, never the cable! Otherwise you risk damaging
the cable. Subsequent damages can affect one or more modules!
Fitting Modules
Step 4 and 5
.0%6-& .0%6-&
Y
Y
'MBUSJCCPODBCMFXJUIFJHIUQMVHTUPQPXFSUIFNPEVMFT
"8":416--0313&445)&1-6(4
/&7&35)&$"#-&
TJMWFSEFDPSBUJPOQBOFM