Filter
Top Products
10
RackPack
Please Note
Fitting and/or exchanging modules should only be done by qualied persons. In the light
of possible physical damage or injuries any manipulation is at your own risk. SPL is not lia-
ble for any physical damage or injury. Before opening the device please read all security
advices (pages 4 and 5) and the “Hook Up” information (pages 7 and 8).
If the device is already in use and you want to expand it with further modules: Turn off the
external power supply before you open the device and wait at least one minute before you
disconnect the device from the external power supply. Also disconnect any signal connec-
tions to other units and wait another ve minutes to make sure no residual current is left
before opening the RackPack.
This instruction explains how to t a module into the third slot. In this example, modules
have already been tted into slot #1 and #2.
You will need the following tools: a Phillips screwdriver and a 4 mm Allen key (the Allen key is
part of the scope of delivery of the RackPack frame).
Step 1 (Top View)
Unscrew all 14 Phillips screws which x the top panel with the Phillips screwdriver and
remove the top panel.
Fitting Modules
Step 1