Filter
Top Products
– 17 –
cam
cam
bracket
(BU adjustment)
magnet ass’y
base unit
0.5 – 2 mm
disc
base unit
holder (disc A2)
disc pulley
disc hole
fixed screw
tapering screwdriver
bracket
(BU adjustment)
magnet ass’y
(1) Rotate the cam and adjust to the position
shown in the figure.
(2) Check that the state is as shown
in the figure.
(3) Remove the Magnet ass’y.
PULLY AND DISC CENTER HOLE ALIGNMENT
Note: The disc should not
be fixed.
(4) Loosen the fixed screw by 60° to 90°, and move and adjust
the bracket (BU adjustment) up and down using a tapering
screwdriver so that the positions of the disc hole and disc
pulley become A=B or between A:B=2:1 and 1:2.