Filter
Top Products
15
K615S-21 13-15
The bias current is now properly adjusted and
the tape sensitivity compensation has been set.
Press p , then press CALIBRATION to turn the
calibration function off (the display returns to
normal). Rewind the tape and start the actual
recording.
4 Adjust BIAS until both meters indicate
equal playback levels.
5 Adjust REC LEVEL for calibration until
both meters reach the recommended
level.
Recommended level
A low reading on the
upper meter indicates a
high bias current.
A high reading on the
upper meter indicates
a low bias current.
An equal reading on both meters indicates the
proper bias current condition.
√
√
√
The Record Muting function allows you to insert a four-
second blank between selections to enable proper Multi-
AMS operation (see page 8), or to replace unwanted
recorded material with a blank of any length.
1 While recording, press and release R .
To create a blank longer than four seconds
Press the R button for the specified length of time. After four
seconds, the REC indicator flashes at a faster rate. When you
release the R button, the P indicator lights up and the unit
goes into recording pause mode.
Press the P button to resume recording.
The REC indicator starts flashing. During this
time, no incoming signals are recorded on the
tape.
After four seconds, the P indicator lights up and
the unit enters recording pause mode.
2 Press P to resume recording.
Inserting a Blank Space During
Recording
— Record Muting
TYPE
L
H
REC CAL
9
9
TYPE
L
H
REC CAL
9
9
BIAS
–
+
BIAS
–
+
TYPE
L
H
REC CAL
9
9
REC LEVEL
–
+
TYPE
L
H
REC CAL
9
9
1
2
POWER
ON
→
BALANCE
LR
•
CALIBRATION
COUNTER
RESET MEMORY
PAUSE
P
REC MUTE
R
REC
rp0
·
)
0 AMS )
MPX FILTER
ON OFFØø
REC LEVEL
0
1
2
3
4
5
6
7
8
9
10
•
•
•
•
•
•
•
•
•
•
OFF
DOLBY NR
B
C
•
•
•
MONITOR
•
S
POWER
REC LEVEL
– +
•
BIAS
– +
•
HEADPHONES
§
EJECT
R
REC MUTE
REC
PAUSE
P