Sony TA-MR2ES Stereo Amplifier User Manual


 
8
US
SONY TA-MR2ES (US) 2-514-603-12(1)
Chapter 2
Setting up the
amplifier
This chapter provides you with
information on the amplifier
regarding installation, hookups and
settings.
Installing the amplifier
7 inches (177.8 mm) minimum
2 inches (50.8 mm)
minimum
When you mount the amplifier, note the following:
Place the amplifier on a flat and level surface.
When installing it in a cabinet, make sure the back of
the cabinet is open to allow adequate ventilation,
prevent heat buildup, and prolong the life of the unit.
Place a board under the amplifier if it is located on a
carpet to allow adequate ventilation on the bottom.
Make sure the weight is equally distributed on each of
its four feet.
Do not place anything on the top of the amplifier that
might block the ventilation holes and cause
malfunction.
Do not place anything on the front or rear panel that
might damage the amplifier’s control buttons and
connectors.
Use caution when placing the unit on surfaces that have
been specially treated (with wax, oil, polish, etc.) as
staining or discoloration of the surface may result.
Leave at least 3 inches (76.2 mm) on each side for
ventilation.
01US04CH2-U.p65 11/30/04, 1:08 PM8