Sony TA-MR2ES Stereo Amplifier User Manual


 
12
US
Setting up the amplifier
SONY TA-MR2ES (US) 2-514-603-12(1)
Setting up the IR ID
You can set up the IR ID when the IR ID TEST switch is in
the “ON” or “OFF” position.
When the IR ID TEST is “ON”
Select this setting to teach the six IR codes below to any
IR-based controller.
IR TEST buttons Function
POWER ON/OFF To turn on or off the power.
POWER ON To turn on the power.
POWER OFF To turn off the power.
MUTING To mute the sound.
VOL – To turn down the volume.
VOL + To turn up the volume.
1 Make sure that the ATTENUATOR L/R is adjusted to
minimum. For details, refer page 14.
2 Turn on the amplifier.
3 Set the IR ID TEST switch to the “ON” position.
The IN USE indicator flashes.
4 To output the IR code, for example ID1, set the IR
ID 1 switch to the “ON” position and set the rest of
the IR ID switches (IR ID 2, 3 and 4) to the “OFF”
position. To select other IR ID, refer to the table
below.
1234
ID1 ON OFF OFF OFF
ID2 OFF ON OFF OFF
ID3 ON ON OFF OFF
ID4 OFF OFF ON OFF
ID5 ON OFF ON OFF
ID6 OFF ON ON OFF
ID7 ON ON ON OFF
ID8 OFF OFF OFF ON
ID9 ON OFF OFF ON
ID10 OFF ON OFF ON
ID11 ON ON OFF ON
ID12 OFF OFF ON ON
If you set the IR ID other than those listed in the table
above, the IR ID will automatically be set to ID1.
IR ID
4321 TEST
OFF
ON
H
X
m
M
.
>
-
x
PL
O
f
F
G
g
IR TEST
IR ID
AUTO POWER SELECTOR 12V TRIGGERIR REMOTE AUDIO
R
R
L
IN OUTINIR IN
4321 TEST12V TRIGGER IR IN AUDIO SENSING
OFF
ON
VOL
VOL
POWER
OFF
POWER
ON
POWER
ON / OFF
MUTING
IR OUT
OUT L
SPEAKERS
AC IN
IR emitter
Learning remote
5 Plug the IR emitter to the IR REMOTE IR OUT jack of
the amplifier.
6 Make sure the learning remote has been set to
learning mode and the IR emitter is touching the
learning remote.
7 Press the IR TEST button for the code you want to
learn.
For example, if you want to learn power on/off, press
POWER ON/OFF.
The IN USE indicator flashes faster. It takes about 2.5
seconds to complete the learning. During this time, if
you press other buttons, they will not function.
If learning is not completed, repeat steps 6 and 7.
6 Repeat steps 6 to 7 to learn other buttons.
You can then use the remote to operate the amplifier.
Tips
• Make sure that the IR ID TEST switch is set to the “OFF”
position and the IR ID switches is set correctly before using the
remote to operate the amplifier. When the IR ID TEST switch is
set to “OFF”, the amplifier will turn on at the previous
operating condition.
• For details on setting the learning remote to learning mode,
refer to the operating instructions supplied with the remote.
01US04CH2-U.p65 11/30/04, 1:08 PM12