Filter
Top Products
24
Recording
5 Press SEARCH/AUDIO ON to return to the
normal display.
6 Press REC z.
Recording begins.
To return to the MAIN MENU screen from the
current menu
Press MENU again.
To go to the next menu from the current menu
Press MENU
V
until “NEXT PUSH
B
” flashes and
press MENU
B
.
Series Recording
Connect another SVT-S480ES for series recording (for
details on connection, see page 11) and set each of the
units as follows.
Item Unit #1 Unit #2 Unit #3 and
subsequent
unit
SERIES REC on ON ON ON
ALARM SET menu
Set the COUNTER/ 0:00:00 0:00:00 0:00:00
REAL TIME switch
to COUNTER.
Cassette tape Loaded Loaded Loaded
Operating status Recording Turned off Turned off
Repeat recording Deactivated Deactivated Deactivated
Security lock Locked Locked Locked
Timer recording Deactivated Deactivated Deactivated
When all of the settings are complete, set unit #1 in
recording mode and turn off the power of unit #2 and
subsequent unit.
When recording on unit #1 is complete, the power for
unit #2 turn on and recording begins.
The unit #1 rewinds its tape when the tape come to the
end and turns off.
Note
For series recording, set SERIES REC in the ALARM SET
menu to ON. If it is set to OFF, recording cannot be done
even if a signal is input to the SERIES IN terminal.
Recording on the Same Cassette
Repeatedly — Repeat Recording
You can record on the same cassette repeatedly in two
different modes: REPEAT 1 and REPEAT 2.
1 Turn on the power of the equipment to be used.
2 Press MENU and MENU
V
until “4” of the MAIN
MENU flashes on the monitor screen.
3 Press MENU
B
.
The GENERAL SET menu appears.
4
Press MENU V to move the flashing to the setting
of
TAPE END MODE
and set to REPEAT 1 or
REPEAT 2 by
pressing MENU + or –
.
The REPEAT indicator lights.
REPEAT 1: If an alarm input is received during
repeat recording, the recording mode switches to
alarm recording. The REPEAT indicator goes
out. After the end of the tape is reached, the tape
is automatically rewound and stops at the
beginning. The OFF indicator lights in the
display window.
REPEAT 2: If an alarm input is received during
repeat recording, the recording mode switches to
alarm recording. Repeat recording will be
performed after alarm recording is finished.
REPEAT
indicator
GENERAL SET
TAPE
TAPE IN
TAPE END MODE
MODE
TAPE USED COUNT
CLOCK ADJUST
APC
THREAD CHECK
T
/
D SEARCH
T–120
STOP
REPEAT 1
OFF
01:00
ON
OFF
CONVENTION
PB S–VHS AUTO
19200
SELECT : DATA SET :
+
/
–
RETURN : MENU
<NEXT PUSH >
BAUD RATE
REC MODE SP
1 2-4 5 6