Filter
Top Products
9
Advanced Tuner Operations
Receiving broadcasts
This tuner lets you enter a station’s frequency
directly by using the numeric buttons (Direct
Tuning). If you do not know the frequency of
the station you want, see “Receiving broadcasts
by scanning stations (Automatic Tuning)” on
page 10.
Before you begin, make sure you have
connected an FM/AM antenna to the tuner as
indicated on pages 5 and 6.
1 Press BAND repeatedly to select FM or
AM (MW and LW).
2 Press DIRECT.
3 Press the numeric buttons to enter the
frequency.
Example 1: FM 102.50 MHz
1 0250
Example 2: AM 1350 kHz
1 350
To receive other stations
Repeat steps 1 to 3.
Tips
• When you tune in AM (MW and LW) stations,
adjust the direction of the AM loop antenna for
optimum reception.
• If the STEREO indicator remains off, press FM
MODE when an FM stereo broadcast is received.
• If you cannot tune in a station and the entered
numbers are flashing, make sure you have entered
the right frequency. If not, press DIRECT and
reenter the frequency you want. If the entered
numbers are still flashing, the frequency is not used
in your area.
• If you enter a frequency not covered by the tuning
interval, the entered value is automatically rounded
up or down to the closest covered value.
Tuning intervals for direct tuning are:
FM:
U.S. models: 100 kHz intervals
Other models: 50 kHz intervals
AM:
U.S. models: 10 kHz intervals
Other models: 9 kHz intervals (MW),
1 kHz interval (LW)
Advanced Tuner Operations
About the menu entry
system
This tuner uses a menu entry system which
allows you to operate various functions by
following messages on the display. Use the
following controls for menu operation.
Use
MENU
TUNING/SELECT
ENTER
RETURN
Customizing the display
You can select the appearance of the display
from one of the following four display modes.
1 Press MENU, then turn TUNING/
SELECT until “Disp-Mode” appears in
the display.
2 Press ENTER.
“Select” appears in the display.
3 Turn TUNING/SELECT to select a
display mode.
Full Display/Full Brightness t Full
Display/Dimmed t Minimal Display/Full
Brightness t Minimal Display/Dimmed
4 Press ENTER.
The setting remains in effect until you
change it again.
If you press one of the buttons on this unit,
the minimal display changes to the full
display with the selected brightness. After
about 4 seconds, the display returns to the
display mode you selected.
To
Enter the menu mode.
Display different items or
settings.
Select the currently displayed
item or setting.
Return to a previous stage in
the menu mode.
Basic Operations/Advanced Tuner Operations
continued