Filter
Top Products
17
Additional Information
Specifications
FM tuner section
Frequency range 87.5 - 108.0 MHz
(U.S. models: 100 kHz
step, other models: 50 kHz
step)
Aerial terminals 75 Ω, unbalanced
U.S. models: F-TYPE
CONNECTOR,
other models: IEC-male
Intermediate frequency
10.7 MHz
Sensitivity at 26 dB quieting (mono)
10.3 dBf, 0.9 µV/75 Ω
at 46 dB quieting (stereo)
38.5 dBf, 23 µV/75 Ω
Usable sensitivity (IHF)
10.3 dBf, 0.9 µV/75Ω
S/N at 40 kHz deviation
74 dB (mono), 69 dB
(stereo)
Harmonic distortion 0.09% (mono),
0.18% (stereo)
Frequency response 30 Hz - 15 kHz
(+0.5/–1.0 dB)
Separation 45 dB at 1 kHz
Selectivity at 400 kHz
85 dB
at 300 kHz
70 dB
Output at 40 kHz deviation
600 mV
AM tuner section
Frequency range
MW:
ST-SE570 522 - 1,611 kHz
(9 kHz step)
ST-SE370
U.S. models: 530 - 1,710 kHz
(10 kHz step*)
Singaporean and Australian models:
531 - 1,710 kHz
(9 kHz step)
Other models: 531 - 1,602 kHz
(9 kHz step)
LW: 144 - 288 kHz
(1 kHz step)
Intermediate frequency
450 kHz
Usable Sensitivity (with AM loop aerial)
MW: 200 µV/m
LW: 700 µV/m
Signal-to-noise ratio
MW: 54 dB
(50 mV/m, 999 kHz)
LW: 50 dB
(50 mV/m, 216 kHz)
Harmonic distortion 0.3% (50 mV/m,
400 Hz)
Selectivity 50 dB
General
Power requirements
U.S. models: 120 V AC, 60 Hz
Australian models: 230 V AC, 50 Hz
Other models: 230 V AC, 50/60 Hz
Power consumption 10 W
Dimensions 430 x 83 x 290 mm
(w/h/d)
Weight 2.5 kg
Supplied accessories
Audio cord (1)
AM loop antenna (1)
FM wire antenna (1)
EON connecting cord (ST-SE570 only, 1)
* (U.S. models only.) You can change the AM tuning
interval to 9 kHz. After tuning in any AM station,
turn off the tuner. Hold down the numeric button 9
and press the POWER button. To reset the scale to
10 kHz, hold down the numeric button 0 and press
the POWER button to turn on the tuner. All preset
stations will be erased when you change the tuning
interval.
Design and specifications are subject to change
without notice.