Filter
Top Products
8
Basic Operations
Presetting radio stations
This section shows you how to store up to 30 of
your favorite FM or AM (FM, MW or LW:
European model) stations manually onto preset
codes made up of characters (A, B, or C) and
numbers (1 - 0), such as A7. You can store up
to 10 stations on each of the 3 different letters.
You can use these letters to classify stations
according to music category or station band.
1 Tune in the FM or AM (MW and LW)
station you want to store (see
“Receiving broadcasts” on page 9).
2 Press MEMORY.
“MEMORY” appears along with the lowest
vacant code to indicate that the tuner is
ready to store the station.
3 Press SHIFT repeatedly to select either
A, B, or C.
The letter you selected appears in the
display.
4 Press a numeric button (1 - 0).
The tuner stores the station at the preset
code you specified.
5 Repeat steps 1 through 4 to store other
stations.
Tips
• When you preset an RDS station broadcasting
station name information, the station name is
automatically stored at the station preset (European
model only).
• If you want to label the stations, follow the
procedure described in “Naming the preset stations”
on page 11.
Receiving preset stations
1 Make sure you’ve hooked up the tuner
and preset stations.
(See pages 5 - 7 for hookups and page 7 or
this page for presetting.)
2 Turn on the amplifier and select the
TUNER mode.
3 Press POWER to turn on the tuner.
4 Press SHIFT repeatedly to select A, B,
or C.
5 Press the preset number you want (1 -
0).
To check broadcasts by scanning
the preset stations
1 Press TUNE MODE repeatedly so that
“PRESET” appears in the display.
2 Turn TUNING/SELECT.
Each time you turn TUNING/SELECT, a
preset station is received and the settings
(preset code, frequency, and station name,
etc.) appear in the display. The signal meter
indicates the strength of the broadcast
signal.
Tip
To tune in a non-preset station, see “Receiving
broadcasts” on page 9.