Filter
Top Products
35
GB
D:\CANNES\SONY_HA\JOB 2007\STR-
DG910\IM_910_CEL\Data_CEL\GB_data\GB03CON_STR-DG910-CEL.fm
masterpage: Right
STR-DG910
3-094-430-31 (1)
Getting Started
Press AUTO CAL.
Measurement starts in 5 seconds and the
display changes as follows:
A. CAL [5] t A. CAL [4] t A. CAL [3] t
A. CAL [2] t A. CAL [1]
The measurement process will take
approximately 30 seconds to complete.
The table below shows the display when
measurement starts.
Note
You cannot measure the speaker height of the
surround speakers and the surround back speakers.
Set this value using the “SUR POS.” parameter in
the SYSTEM menu (page 58).
Tip
The measurements may not be performed correctly
or Auto Calibration cannot be performed when
special speakers, such as dipole speakers are used.
To cancel Auto Calibration
The Auto Calibration function will be
canceled when you do the following during the
measurement process:
– Press ?/1, input buttons or MUTING.
– Press SPEAKERS (OFF/A/B/A+B) on the
receiver.
– Change the volume level.
– Press AUTO CAL again.
– Connect the headphones.
Performing Auto Calibration
TUNING –
MUTING
TV VOL
MASTER VOL
TV CH
PRESET
GUIDE DISPLAY
RETURN/
EXIT
TV
VIDEO 1 VIDEO 2 VIDEO 3 DVD
SAT TV TUNER
2CH A.F.D. MOVIE MUSIC
SA-CD/CD
AUX DMPORT RECEIVER
?/1
MEMORY
.
>
xX
MENU
H
CLEAR
>10
-
/
--
<
<
DVD
23
456
789
ENTER
0/10
1
AUTO CAL
B
V
v
B
RM SET UP
AV ?/1
SYSTEM S ANDBYT
FM MODE D.TUNING
REPLAY ADVANCE
SLEEP
OPTIONS
TOOLS
DISC SKIP
TUNING
+
m
M
,
V/v
AUTO
CAL
Input
buttons
?/1
switch
MUTING
MASTER
VOL +/–
RECEIVER
Measurement for Display
Speaker existance TONE
Speaker gain, distance,
frequency response
T.S.P.
Sub woofer gain and distance WOOFER