Filter
Top Products
31
GB
D:\CANNES\SONY_HA\JOB 2007\STR-
DG910\IM_910_CEL\Data_CEL\GB_data\GB03CON_STR-DG910-CEL.fm
masterpage: Right
STR-DG910
3-094-430-31 (1)
Getting Started
5: Preparing the receiver
and the remote
If your receiver has a voltage selector on the
rear panel, check that the voltage selector is set
to the local power supply voltage. If not, use a
screwdriver to set the selector to the correct
position before connecting the AC power cord
to a wall outlet.
Connect the AC power cord to a wall outlet.
* Models of area code E2 only.
Notes
•The AC OUTLET on the rear of the receiver is a
switched outlet, which supplies power to the
connected component only while the receiver is
turned on.
•Make sure that the total power consumption of the
component connected to the receiver’s AC
OUTLET does not exceed the wattage stated on the
rear panel. Do not connect high-wattage electrical
home appliances such as electric irons, fans, or
TVs to this outlet. This may cause a malfunction.
Setting the voltage selector
Connecting the AC power cord
VOLTAGE
SELECTOR
120V
220V
240V
AC OUTLET
SURROUNDSURROUND BACK
R
R
L
L
E
AKERS
FRONT BFRONT A
R
R
LL
SPEAKERS
AC power cord
To the wall outlet
AC OUTLET*