Filter
Top Products
16
EN
Preparing and Using the Remote
If the on-screen display does not appear even after the
batteries have been inserted into the remote (see page
14), reinsert the batteries and place the remote on a flat
surface for about 10 seconds.
Hints on handling the remote
• A slight wrist movement is all you need to direct the
pointer. (See previous illustration.)
• Hold the remote with its “click” button facing up, as
shown below. If the click button is oriented
diagonally, the pointer will not move in the same
direction that you move the remote.
• The pointer will not move if you move the remote
along a flat plane as shown below.
• The on-screen display disappears automatically after
a few seconds when you place the remote on a flat
surface.
To make the on-screen display disappear faster,
position the pointer in the blank area, hold down the
click button to vanish the display, then place the
remote on a flat surface and release the click button.
To recall the on-screen display, pick up the remote.
Notes
• The position of the pointer freezes when you hold down
the click button.
• If the pointer begins drifting on the screen even while the
remote is stationary, place the remote on a flat surface
until the on-screen display disappears. The pointer
should behave normally the next time you use the remote.
• If your hand is very dry, the on-screen display may not
appear when you touch the click button. In this case, press
the click button.
Caution
Since the remote contains delicate circuitry and parts, do not
subject it to sudden changes in temperatures or to shock.
How to Use the Remote:
STR-DE805G
The supplied remote lets you perform almost all of the
receiver operations. Operation is simple, press the
direction control button on the remote once to recall
the on-screen display, then press the corner of the
direction control pad representing the direction you
want to move the pointer (hand shaped icon) on the
on-screen display. Position the pointer so that the
finger tip is positioned on one of the on-screen items,
then press and quickly release the center of the
direction control button to “click” the item.
To turn on the receiver
Press the direction control button on the remote once or
twice to turn on the unit.
Hints on handling the remote
• Do not cover the IR emitter when operating the
remote.
• Hold the remote with its direction control button
facing up, as shown below.
• To make the on-screen display disappear, position
the pointer in the blank area, and press the center of
the direction control button.
()0pP=+
FUNCTION
+
–
VOL
ALL
OFF
USERSUB
S
O
U
N
D
PUSH
ENTER
Mm
Â
µ
Pointer
Blank
area
Direction
control
button
30°
Be sure your hand
does not cover this part
IR rays