Filter
Top Products
masterpage:Left
lename[E:\SEM_Janet\Revision
D
ata\J9051275_2598516131DB798CEL\2598516131\GB070TH_STR-DB798-CEL.fm]
46
GB
model name1[STR-DB798]
[2-598-516-13(1)]
You can select the front speaker system you
want to use.
Press SPEAKERS (OFF/A/B/A+B)
repeatedly to select the front speaker
system you want to use.
The selected speaker system indicator lights up
in the display. To turn off the speaker output,
press SPEAKERS (OFF/A/B/A+B) repeatedly
until “SP A” and “SP B” indications in the
display turn off.
* (Except for models of area code CEK)
When the IMPEDANCE SELECTOR is set to “8Ω”,
connect the speakers with a nominal impedance of
16 ohms or higher. When the IMPEDANCE
SELECTOR is set to “4Ω”, connect the speakers
with a nominal impedance of 8 ohms or higher. For
details, see “Speaker impedance” on page 14.
(Models of area code CEK only)
If you connect speakers to both SPEAKERS FRONT
A and B terminals, connect the speakers with a
nominal impedance of 16 ohms or higher.
Before you begin, make sure you have
connected all components properly.
Recording on an audio tape or
MiniDisc
You can record on a cassette tape or MiniDisc
using the receiver. See the operating instructions
of your cassette deck or MD deck if you need
help.
1 Select the component to be recorded.
2 Prepare the component for playing.
For example, insert a CD into the CD
player.
3 Insert a blank tape or MiniDisc into the
recording deck and adjust the
recording level, if necessary.
4 Start recording on the recording deck,
then start playback on the playback
component.
Notes
• You cannot record a digital audio signal using a
component connected to the analog MD/TAPE OUT
jacks. To record a digital audio signal, connect a
digital component to the DIGITAL OPTICAL
MD/TAPE OUT jack.
• Sound adjustments do not affect the signal output
from the MD/TAPE OUT jacks.
• The analog audio signals of the current input is
output from the MD/TAPE OUT jacks.
• The signals input to the MULTI CH IN jacks are not
output from the MD/TAPE OUT jacks even when
MULTI CH IN is being used. The analog audio
signals of the current or previously used input are
output.
• No signals are output from DIGITAL OPTICAL
MD/TAPE OUT jack when ANALOG DIRECT
function is being used. The digital circuitry power is
cut off to ensure superior sound quality when
“D.PWR XXX” is set to “D.PWR OFF”.
• Some sources contain copy guards to prevent
recording. In this case, you may not be able to record
from the sources.
Selecting the speaker
system
To select Indicator
lights up in
the display
The speaker connected to the
SPEAKERS FRONT A terminals.
SP A
The speaker connected to the
SPEAKERS FRONT B terminals.
SP B
The speakers connected to both the
SPEAKERS FRONT A and B
terminals (parallel connection).*
SP A and SP B
Recording
GB01COV_STR-DB798-CEL.book Page 46 Thursday, August 18, 2005 8:59 AM