Filter
Top Products
55
GB
Amplifier Operations
* After the measurements are completed using auto calibration, the measurement value is displayed as
xmxxcm.
** After the measurements are completed using auto calibration, you can adjust them in 1cm increments.
7-Speaker
Settings
SUB WOOFER [xxx] NO, YES YES page 63
- 67
FRONT SP [xxxxx] SMALL, LARGE LARGE
CENTER SP [xxxxx] MIX, NO, SMALL, LARGE LARGE
SURROUND SP [xxxxx] NO, SMALL, LARGE LARGE
SUR BACK SP [xxxxxx] BI-AMP, NO, SINGLE, DUAL DUAL
FRONT L x.xmeter* 1.0m to 7.0m (0.1m** step) 3.0 meter
FRONT R x.xmeter* 1.0m to 7.0m (0.1m** step) 3.0 meter
CENTER x.xmeter* 1.0m to 7.0m (0.1m** step) 3.0 meter
SURROUND L x.xmeter* 1.0m to 7.0m (0.1m** step) 3.0 meter
SURROUND R x.xmeter* 1.0m to 7.0m (0.1m** step) 3.0 meter
SUR BACK L x.xmeter* 1.0m to 7.0m (0.1m** step) 3.0 meter
SUR BACK R x.xmeter* 1.0m to 7.0m (0.1m** step) 3.0 meter
SUB WOOFER x.xmeter* 1.0m to 7.0m (0.1m** step) 3.0 meter
DISTANCE UNIT
[xxxxx]
meter, feet meter
SP POSI [xxxxxxxxx] SIDE/LOW, SIDE/HIGH, BEHD/
LOW, BEHD/HIGH
SIDE/
LOW
SP CROSSOVER [xxxHz] 40Hz to 200Hz (10Hz step) 120Hz
8-System
Settings
DIMMER [xxx% DOWN] 0%, 60%, 100% 0% page 67
SP. IMPEDANCE [xxxx] 4 ohm, 8 ohm 8 ohm page 38
9-Auto
Calibration
AUTO CAL START? page 45
- 46
CAL TYPE
[xxxxxxxxx]
ENGINEER/FULL FLAT/FRONT
REF
FULL FLAT
EQ CURVE EFFECT [xxx] OFF, ON OFF
A.CAL LOAD? [PRESET- x] OFF, PRESET1, PRESET2, PRESET3 OFF
A.CAL SAVE? [PRESET- x] PRESET1, PRESET2, PRESET3
PRESET1
A.CAL NAME?
[xxxxxxxxx]
page 84
Menu Item Parameter Initial
setting
Refer
page