Filter
Top Products
42
GB
6 Press V/v repeatedly to select
“CAL TYPE,” then press to
enter the parameter.
7 Press V/v repeatedly to select
the parameter, then press to
enter the selection.
8 Press V/v repeatedly to select
“AUTO CAL START,” then press
to start the measurement.
Measurement starts in five seconds. A
countdown appears on the TV screen.
While the time is counting down, stand
away from the measurement area to
avoid measurement error.
9 Measurement starts.
The measurement process will take
approximately 30 seconds. Wait until the
measurement process completes.
Note
You cannot measure the speaker height of the
surround speakers and the surround back speakers.
Set this value from “SP POSI.” settings in the
Speaker Settings menu (page 66).
Tips
• Operations other than turning the receiver on or off
and pressing ON SCREEN to turn the display on or
off are deactivated during auto calibration.
• When special speakers, such as dipole speakers are
used, the measurements may not be performed
correctly or auto calibration cannot be performed.
To cancel auto calibration
Auto calibration is cancelled when you change
the volume, switch functions, change the
speaker setting of the receiver, or connect
headphones.
Calibration
type
Explanation
ENGINEER Sets the frequency
characteristics to a set that
matches that of the Sony
listening room standard.
FULL FLAT Makes the measurement of
frequency from each
speaker flat.
FRONT REF Adjusts the characteristics
of all the speakers to match
the characteristics of the
front speaker.