Sony STR-DA1200ES Stereo Receiver User Manual


 
104
GB
Recording cannot be carried out.
Check that the components are connected
correctly (page 24).
Select the source component using INPUT
SELECTOR (page 47).
Tuner
The FM reception is poor.
• Use a 75-ohm coaxial cable (not supplied)
to connect the receiver to an outdoor FM
antenna (aerial) as shown below. If you
connect the receiver to an outdoor antenna
(aerial), ground it against lightning. To
prevent a gas explosion, do not connect the
ground (earth) wire to a gas pipe.
Radio stations cannot be tuned in.
• Check that the antennas (aerials) are
connected securely. Adjust the antennas
(aerials) and connect an external antenna
(aerial), if necessary.
The signal strength of the stations is too
weak (when tuning in with automatic
tuning). Use direct tuning.
• Make sure you set the tuning interval
correctly (when tuning in AM stations
with direct tuning).
• No stations have been preset or the preset
stations have been cleared (when tuning by
scanning preset stations). Preset the
stations (page 80).
• Press DISPLAY so that the frequency
appears on the display.
RDS does not work.
Make sure that you are tuned to an FM
RDS station.
• Select a stronger FM station.
The RDS information that you want
does not appear.
• Contact the radio station and find out
whether or not they actually provide the
service in question. If so, the service may
be temporarily out of order.
Remote control
The remote does not function.
• Point the remote at the remote sensor on
the receiver.
Remove any obstacles in the path between
the remote and the receiver.
Replace all the batteries in the remote with
new ones, if they are weak.
Make sure that the command modes of the
receiver and the remote are the same. If the
command mode of the receiver and the
remote are different, you cannot operate
the receiver with the remote (page 37).
• Make sure you select the correct input on
the remote.
When you operate a programmed non-
Sony component, the remote may not
function properly depending on the model
and the maker of the component.
Receiver
To ground
Ground (earth) wire (not supplied)
Outdoor FM antenna (aerial)