Filter
Top Products
6
GB
Getting Started
Setting Up the Remote
This section describes how to prepare the supplied
remote for operation.
Press I/u on the player to turn the player on.
If the following message appears in the remote’s
display while setting up the remote, point the remote
at the player as illustrated below.
Note that the display disappears automatically if you
don’t proceed for more than a few moments.
MENU
Easy scroll
key
30°
I/u
an ' t recei ve
elPaseturn
to a main unit
hi
C
tsREMOTE
CONTINUE
PROGRAM
MEMO SCAN
MENU
PUSH ENTER
TRACK
PLAYER SELECT
BACK
DISC
SKIP
SHUFFLE
REPEAT
TIME/TEXT
Turning off the player’s response to remote
signals
To use the remote supplied with another component
compatible with the 2 way remote system, you must
turn off this player’s response to signals of the remote
supplied with this player.
Set the 2 way remote system to off when:
• you use the remote as RM-TP501, RM-TP501E,
RM-LJ301 supplied with the receiver/amplifier (you
can operate Disc 1 to Disc 200 only).
• you use the remote with the
mark supplied with
the receiver/amplifier.
1 Press MENU/NO.
2 Turning the JOG dial until “2WAY OFF ?” appears
in the display window.
3 Press YES.
When you connect the player to CDP-CX260 or CDP-
CX88ES, press OPERATE on the transmitter/receiver
to turn it off, and set the 2 way remote system of the
player to on.
To return to normal setting
After following steps 1 and 2, and “2WAY ON ?” is displayed,
then press YES.
Notes
• When you use the remote to operate more than one unit,
position the units so that each unit can receive the signals of
the remote.
• When you use this player with a receiver/amplifier, turn
the receiver/amplifier on when using this player.
MENU/NO YES
JOG
I / u
+100