Filter
Top Products
3-859-278-11(1)
Operations Using the Optional Remote
26
EN
The Optional Remote RM-D750
You can do the following operations using serial
remote control with an optional remote RM-D750
which may be either connected to the REMOTE 2
connector on the rear panel or not. For more
information on other remote operations that are
possible, refer to the Operating Instructions of the
remote.
Note
Set REMOTE on the front panel to WIRED when the remote
is connected to the deck. When using it remotely, set
REMOTE to WIRELESS.
Playing tracks in the order you want (RMS*
Play)
RMS Play allows you to specify the playback order of
the tracks on the tape to create your own programs
containing up to 60 tracks (using program numbers 1
to 99). To use RMS Play, however, you must first
record start IDs and program numbers on the tape.
Checking the track order
You can check the order of tracks in your program by
pressing the RMS CHECK button. Each time you press the
RMS CHECK button, the track numbers appear in the order
they were programmed.
Note
You cannot use the CLEAR button to cancel a programmed
track while checking the track order.
To add a track to a program
Repeat steps 1 and 2 while the deck is stopped.
Note
You cannot add a track to a program after RMS Play has
started.
To cancel an entire program
Press p repeatedly until “RMS” disappears.
Locating a track by scanning each track
(Music Scan)
You can locate a track by scanning the first 8 seconds of
each track.
1 Press M.SCAN while the deck is stopped.
2 Press ·.
The deck plays the first 8 seconds of each track in
succession.
3 When you find the track you want, press
M.SCAN.
The track continues playing.
z You can use Music Scan while playing a track
If you press the M.SCAN button while playing a track,
the deck will rewind the tape to its beginning, then play
the first 8 seconds of each track on the tape in
succession.
Operations Using the Optional Remote
CLEAR
RMS
CHECK
RMS
ENTER
·p
3
6
9
WRITE
WRITE
2
5
8
0
RENUMBER
START ID
PRESENT
SKIP
PLAY
REHEARSAL
SKIP ID
ERASEWRITE
1
4
7
AUTO
OPEN/
CLOSE
REHEARSAL
MODE
REHEARSAL
FADER
INPUT
MONITOR
ERASE
RESET
ERASE
RECORDED
M.SCAN REPEAT
MARGIN
RESET
CLEAR
0
= r
·
)
+ R
P p
END ID
CHECK ENTER
LOCATE MARK
RMS
COUNTER
DATE
AMS
6
Number buttons
1 Enter the program number (1 to 99) of the track
you want to play.
If you‘ve entered the wrong number
Press CLEAR, then enter the correct number.
2 Press RMS ENTER.
3 Repeat steps 1 and 2.
4 Press ·.
The deck starts playing the programmed tracks in
sequence.
* RMS = Random Music Sensor
RMS
ST EP 1
5
Playing
order
Program
number
M.SCAN
·
3
6
9
WRITE
WRITE
2
5
8
0
RENUMBER
START ID
PRESENT
SKIP
PLAY
REHEARSAL
SKIP ID
ERASEWRITE
1
4
7
AUTO
OPEN/
CLOSE
REHEARSAL
MODE
REHEARSAL
FADER
INPUT
MONITOR
ERASE
RESET
ERASE
RECORDED
M.SCAN REPEAT
MARGIN
RESET
CLEAR
0
= r
·
)
+ R
P p
END ID
CHECK ENTER
LOCATE MARK
RMS
COUNTER
DATE
AMS
6