Filter
Top Products
NWA1000/NW-A3000.GB.2-659-086-11(1)
Troubleshooting
71
71
Others
Symptom Cause or corrective action
There is no beep sound
when the player is
operated.
“Beep” is set to “Off.” Set it to “On” (
page 48).
The player gets warm.
The player may be warm when the battery is being
charged and just after charging. The player also
may get warm when a large number of tracks are
transferred. This behavior is normal and not cause
for concern. Set the player aside for a while to
allow it to cool down.
Noise comes from the
inside of the player, or
the player shakes.
As the built-in hard disk of the player starts, stops,
is read from, and is written to, sound and vibration
from these operations may be perceptible. This
behavior is normal and not cause for concern.
The screen turns on
whenever tracks change.
“Display” is set to “Auto 2.” Set it to “Auto 1” or
“15 sec” (
page 50).
The player does not lie in
a stable position.
The player does not lie in a stable position on a flat
surface such as a table. Carry the player in your
hand, or hold the player in your hand while your
hand rests on the flat surface.
The player has no stop
button.
With this player, there is no difference between
stopping and pausing.
Charging completes very
quickly.
If the battery is already almost fully charged when
charging begins, little time is needed to reach a full
charge. When charging finishes, lights up on
the player, and the light on the USB cable turns
off.
Table of
Contents
Index
Menu