Filter
Top Products
25
MZ-NF610
Power Supply Adjustment Auto Item Feed
Note: This mode is available to perform the temperature correction and
power supply adjustment without entering the manual mode.
• Setting method of power supply adjustment auto item feed mode.
1. Set the test mode (see page 13)
2. Press the . key or press the [VOL --] key on the remote
commander to activate the overall adjustment mode.
3. Press the [END SEARCH] key to set the temperature correc-
tion mode.
4. To change the initial value (not displayed) adjust with the [VOL
+] or [VOL --] key.
Press the X key to write the adjusted value, and the item num-
ber increases automatically.
When not writing the adjusted value, press the > key to
move to the next item.
000 Assy **
Set LCD display
0 15 SetTmp
Set LCD display
7 41 VC1 L
Set LCD display
0 00 ADJ OK
Set LCD display
. key
> key
. key
> key
. key
> key
. key
> key
. key
> key
END SEARCH key
000Assy **
015 SetTmp
741 VC1 L
742 VC1 H
743 VC2 Lo
744 VC2 Hi
745 REG1
. key
> key
> key
> key
> key
. key
> key
. key
> key
752 VREC M
753 VREC H
755 ChgV L
756 ChgV H
. key
> key
757 CIL **
. key
> key
758 CIH **
000 ADJ OK
> key
. key
. key
> key
747 REG3L1
748 REG3L2
> key
. key
749 REG3 H
751 VREC L
. key
. key
5. Connect a digital voltmeter to the measuring points on the MAIN
board, and adjust the voltage with the [VOL +] or [VOL --] key.
(see page 19 to 23)
Press the X key to write the adjusted value, and the item num-
ber increases automatically.
6. When not writing the adjusted value, press the > key to
move to the next item. The . key is available to back to the
last item.
7. The following message is displayed after all power supply
adjustments finish.
8. Press the xCANCEL/CHG key to return the test mode (dis-
play check mode).
• Configuration of power supply adjustment auto item feed