Filter
Top Products
17
MZ-NF610
• Cause of Sound Skip Error
Cause of error Description of error
EIB Sound error correction error
Play
Stat Decoder status error
Adrs Address access error
BEmp Buffer is empty
BOvr
Buffer is full, and sounds were
dumped
Record
Bful
Buffer capacity becomes less,
and forcible writing occurred
Rtry Retry times over
4. To quit the sound skip check result display mode and to return
to the test mode (display check mode), press the xCANCEL/
CHG key.
• Setting Method of Key Check Mode
1. Set the test mode (see page 13).
2. Press the
[VOL -] key activates the key check mode.
3. When each key on the set and on remote commander is pressed,
its name is displayed on the set LCD. (Operated position is
displayed for 4 seconds after the slide switch is operated.
Example1: When the > key on the set is pressed:
Example2: When the u /ENT key on the remote commander
is pressed:
Sound Skip Check Result Display Mode
This set can display the count of errors that occurred during the
recording/playing for checking.
• Setting Method of Sound Skip Check Result Display
Mode
1. Set the test mode (see page 13).
2. Press the ENTERN key or [VOL+] key, and the playing or
recording sound skip result display mode becomes active re-
spectively where the LCD displays the following.
3. When the
ENTERN key is pressed, total error count is dis-
played on the LCD, and each time the > key is pressed,
the display item moves down by one as shown below. Also, if
the . key is pressed, the display item moves up by one,
then if the [VOL+] key is pressed, the display in the record
mode appears.
When the [VOL +] key is pressed, total error count is displayed
on the LCD, and each time the > key is pressed, the display
item moves down by one as shown below. Also, if the . key
is pressed, the display item moves up by one, then if the
ENTERN key is pressed, the display in the play mode ap-
pears.
0 00 P**R**
0 00 EIB **
0 00 Stat**
0 00 Adrs**
0 00 BEmp**
0 00 ######
0 00 P**R**
0 00 BOvr**
0 00 Bful**
0 00 Rtry**
0 00 ######
P**R**: Total play/record errors (hex.)
** : Counter of sound skip check each item (hex.)
######: 6-digit address where sound was skipped last (hex.)
Playing sound skip
result display
Recording sound skip
result display
000
Set LCD display
0 00 FF
Set LCD display
000 r P PUS
Set LCD display
0 00 P**R**
Total count of play
system errors (hex.)
Total count of record
system errors (hex.)
Set LCD display