Filter
Top Products
9
Getting Started
Setting the time
1 Turn on the system.
2 Press CLOCK/TIMER (or CLOCK/TIMER
SET on the remote).
When you set the time for the first time,
proceed to step 5.
3 Press O or o repeatedly to select
“CLOCK SET”.
4 Press ENTER (A/V amplifier or remote).
5 Press O or o repeatedly to set the hour.
6 Press ENTER (A/V amplifier or remote).
7 Press O or o repeatedly to set the
minutes.
8 Press ENTER (A/V amplifier or remote).
Tip
If you have made a mistake or want to change the
time, start over from step 2.
Note
The clock settings are canceled when you disconnect
the power cord or if a power failure occurs.
Tip
You can place the components as described below. In
this case, place the components first, then connect the
components.
Note
Keep the speaker cords away from the antennas to
prevent noise.
Inserting two size AA (R6)
batteries into the remote
Tip
When the remote no longer operates the system,
replace both batteries with new ones.
Note
If you do not use the remote for a long period of time,
remove the batteries to avoid possible damage from
battery leakage.
Notice for carrying this system
Do the following to protect the CD
mechanism.
1 Turn on the system, then turn
FUNCTION to select “CD”.
Make sure that all discs are removed
from the unit.
2 While holding down EQ ON/OFF, press
?/1 until “LOCK” appears.
3 Release ?/1 first, then release EQ ON/
OFF.
4 Unplug the AC power cord.
]
}
]
}
A/V amplifier
Cassette deck
Tuner CD player