26
Press
SLEEP once.
SLEEP repeatedly to select
the time you want.
SLEEP repeatedly until
“SLEEP OFF” appears.
Other Features
Changing the spectrum
analyzer display
Press and hold DISPLAY for more than 2
seconds.
Each time you press the button, the display
changes as follows:
SPECTRUM ON y SPECTRUM OFF
To adjust the brightness
of the display
1 Press SET UP.
2 Press P or p repeatedly to select
“DIMMER”.
3 Press ENTER (A/V amplifier or remote).
4 Press O or o repeatedly to select the
setting you want.
The setting is stored.
5 Press ENTER (A/V amplifier or remote).
Falling asleep to music
— Sleep Timer
You can set the system to turn off at a preset
time, so you can fall asleep to music.
Press SLEEP on the remote.
Each time you press the button, the minute
display (the turn-off time) changes as follows:
OFF t AUTO* t 90min t 80min t
70min t … t 10min
* The power turns off when the current CD or tape
finishes playback (for up to 100 minutes).
To
Check the remaining
time
Change the time to
turn off
Cancel the Sleep
Timer
Waking up to music
— Daily Timer
You can wake up to music at a preset time
every day. Make sure you have set the clock
(see “Setting the time” on page 9).
1 Prepare the music source you want to
play.
• CD: Load a CD. To start from a specific
track, make a program (see
“Programming the CD tracks” on page
12).
• Tape: Load a tape with the side you
want to play facing forward.
• Radio: Tune in the preset station you
want (see “Listening to the radio” on
page 14).
2 Adjust the volume.
3 Press CLOCK/TIMER (or CLOCK/TIMER
SET on the remote).
“DAILY1 SET” appears.
4 Press O or o repeatedly to select
“DAILY 1 (or 2)”, then press ENTER
(A/V amplifier or remote).
“ON” appears and the hour indication
flashes.