Sony MHC-RV6/RV5 Stereo System User Manual


 
Troubleshooting
37
GB
There is severe hum or noise.
A TV or VCR is placed too close to the stereo
system. Move the stereo system away from the
TV or VCR.
The timer does not function.
Set the clock correctly.
DAILY 1, DAILY 2 and REC do not appear
when you press CLOCK/TIMER SELECT.
Set the timer correctly.
Set the clock.
The remote does not function.
There is an obstacle between the remote and the
system.
The remote is not pointing in the direction of the
systems sensor.
The batteries have run down. Replace the
batteries.
There is acoustic feedback.
Reduce the volume.
Move the microphone away from the speakers or
change the direction of the microphone.
The color irregularity on a TV screen persists.
Turn off the TV set once, then turn it on after 15
to 30 minutes. If the color irregularity still
persists, place the speakers farther away from the
TV set.
Speakers
Sound comes from one channel or unbalanced
left and right volume.
Check the speaker connection and speaker
placement.
Sound lacks bass.
Check that the speakers + and jacks are
connected correctly.
Troubleshooting
Problems and remedies
If you have any problem using this system, use
the following check list.
First, check that the power cord is connected
firmly and the speakers are connected correctly
and firmly.
Should any problem persist, consult your
nearest Sony dealer.
General
The display starts flashing as soon as you plug
in the power cord even though you have not
turned on the system (see step 5 of Hooking up
the system on page 6).
Press DISPLAY twice while the system is off.
The demonstration disappears.
“– : –” lights in the display.
A power interruption occurred. Set the clock and
timer settings again.
The clock setting/radio presetting/timer is
canceled.
The power cord is disconnected or a power
failure occurs longer than half a day.
Redo the following:
—“Setting the clock on page 9
—“Presetting radio stations on page 20
If you have set the timer, also redo Waking up
to music on page 33 and Timer-recording radio
programs on page 25.
There is no sound.
Turn VOLUME (or press VOL + on the remote)
clockwise.
The headphones are connected.
Insert only the stripped portion of the speaker
cord into the SPEAKER jack. Inserting the vinyl
portion of the speaker cord will obstruct the
speaker connections.
There is no audio output during timer recording.
continued